Your SEO optimized title page contents
Stampin' Up! Way to Goat
Stampin' Up! Seas the Day

Stampin' Up! Hand-Penned Banner Card

274928954_10158546927061981_4602772873382657835_n
All images © 1990-2022 StampinUp!

Supplies: 

  • Stamp Set: Shaded Summer Cling Stamp Set [155783]
  • Card Stock:  Basic White [159276], Daffodil Delight [119683], Blushing Bride [131198], Garden Green [102584], Hand Penned 12" X 12" (30.5 X 30.5 Cm) Designer Series Paper [155499]
  • Misc.: Whisper White 1/4" (6.4 Mm) Crinkled Seam Binding Ribbon [151326], Elegant Faceted Gems [152464], Ornate Floral 3D Embossing Folder [152725], Stampin' Cut & Emboss Machine [149653], Tear & Tape Adhesive [138995], Mini Glue Dots [103683], Multipurpose Liquid Glue [110755], Stampin' Dimensionals [104430], Bone Folder [102300], Paper Snips [103579], Clear Block C [118486], Penned Flowers Dies [155557]

 

Measurements:

  • Basic White : 8 ½” x 5 ½” , 3 ¾” x 2 ½”
  • Blushing Bride: 4” x 5 ¼” , 3 ¾” x ¾”
  • Daffodil Delight: 3 ¾” x 2 ½”
  • Designer Series Paper: ¾” x 1, ¾” x 1 ¼”, ¾” x 1 ½”, ¾” x 1 ¾” (X2), ¾” x 2” (X2)

 

Instructions:

  1. Fold 8 ½” x 5 ½” Basic White card stock in half to create card base.  
  2. Glue 4” x 5 ¼” piece of Blushing Bride card stock to front of card.
  3. Run Daffodil Delight card stock through embossing folder and glue to card, along the bottom.
  4. Stamp sentiment from “Shaded Summer” set with Black Memento ink onto 3 ¾” x 2 ½” Basic White card stock. Glue above the Daffodil Delight card stock layer.
  5. Place a strip of Tear & Tape adhesive along the middle, where the Daffodil Delight and Basic White card stocks meet. Remove backing.
  6. Flag each piece of Designer Series Paper using Paper Snips (cut up the middle of bottom edge and then cut corner to centre on each side). You've now got seven banners!
  7. Position the banners across the middle of your card, along the Tear & Tape adhesive.
  8. Run 3 ¾” x ¾” Blushing Bride card stock through die cutting machine using the scalloped border die.
  9. Place Tear & Tape adhesive across the middle of 3 ¾” x ¾” strip of Blushing Bride card stock. Peel off backing and place ribbon on top, securing in the back. Glue across the centre of card.
  10. Use dies to cut leaves from Garden Green card stock and three flowers from Blushing Bride card stock. Adhere the flowers to front of card using a Stampin' Dimensional between each one. Adhere the leaves with Multipurpose Liquid Glue.
  11. Place gems in centre of flower.
  12. Make a ribbon bow and place onto card using Mini Glue Dots to hold into place.

 

 

Product List

Comments